ServicesPool Repair
Pool Repair in Higley
When a pump goes quiet or a filter stops holding pressure, we find the cause and fix it properly. You get a written estimate that weighs the repair against the remaining life of the equipment, so the money you spend now still makes sense in a few years.
Repairs that account for what comes next
Most pool problems start at the equipment pad. A motor bearing wears out, a shaft seal starts to weep, a capacitor fails, or a cracked fitting lets air into the line. We work on the parts that keep water moving, filtered and heated, and we bring the circulation system back to steady, quiet operation.
A cheap fix is not always the better value. A new seal on a pump with a tired motor may buy only a few months. We tell you how old the equipment is, what condition the rest of it is in, and what each choice is likely to cost over the next several seasons. Then you decide.
Summer here asks a lot of a pump, which often runs long hours to keep up with heat and sun. Repairs that are done carefully, with the right parts and properly seated gaskets, hold up through that kind of season.
What our pool repair covers
- Pumps and motors
- We replace bearings, shaft seals, capacitors, impellers and lid o-rings, and we diagnose motors that hum without starting. When a single-speed pump is near the end, we can show you how a variable-speed model compares over time.
- Filters and valves
- Cracked cartridge housings, worn multiport valve gaskets, broken pressure gauges and stuck relief valves. We check that the filter is sized right for your pool while we are there.
- Heaters
- We look at ignition, sensors, pressure switches and scale buildup in heat exchangers. If the heater is not worth repairing, we say so and explain why.
- Equipment-pad plumbing
- Weeping unions, cracked PVC fittings and failed valve diverters above ground. We cut back to clean pipe and glue new fittings with the right primer and cement.
- Skimmers, returns and small parts
- Broken skimmer lids, weir doors, baskets, return eyeballs and drain covers. Small parts, but they protect the pump and keep water flowing where it should.
Signs your pool needs repair
Grinding or screeching from the pump
That sound usually means the motor bearings are going. Caught early, it can be a bearing job instead of a new motor.
Air in the pump basket
Bubbles in the lid or returns that spit air point to a suction-side leak, often a worn lid o-ring or a cracked fitting.
Filter pressure that will not settle
Pressure that climbs right after a cleaning, or stays unusually low, can mean a clogged line, a damaged cartridge or a problem with the pump itself. Our Filter Cleaning service handles routine buildup; a repair visit finds the cause when cleaning does not.
Water around the equipment
A damp pad or a steady drip under the pump means a seal or union is failing. Water near a motor deserves attention before it reaches the windings.
A heater that will not fire
Clicks with no flame, or an error code that keeps coming back, usually trace to a sensor, switch or flow issue.
Tripped breakers
If the pump trips its breaker, turn it off and leave it off until it has been checked.
How a repair visit goes
- 1
A short call
Tell us what you are hearing or seeing and the make of your equipment if you know it. We set a time that works for you and your home.
- 2
Diagnosis at the pad
We test the pump, filter, heater and plumbing, not just the part that seems broken. You see what we found and why it matters.
- 3
A written estimate with options
Each line is listed. Where it makes sense, we price both the repair and the replacement and note the likely life of each, so the comparison is clear before any work starts.
- 4
The repair, then a full test
We make the repair, prime the system, check pressure and flow, and watch for leaks. Old parts and packaging leave with us, and the pad is left clean.
What affects the cost of a pool repair
The price depends on the part, the equipment it belongs to and how much else needs attention. We quote after we have looked, and the estimate you approve is the work we do. If we find something else along the way, we stop and talk with you first.
- The part and the brand
- Common seals and o-rings are simple. Motors, heater boards and discontinued parts cost more and can take longer to source.
- Age of the equipment
- On older equipment, a repair may be fair value or may be money spent on a system close to replacement. We show you both sides.
- Condition of the plumbing
- Brittle, sun-faded PVC around a failed fitting often needs a longer section replaced so the new joint lasts.
- Access and layout
- Tight pads, buried unions or equipment set close to walls take more time to work on safely.
Pool repair questions
Something not covered here? (480) 571-2998
Should I repair my old pump or replace it?
It depends on the motor, the wet end and what you pay to run it. If the motor is sound, a seal or bearing job is usually good value. If it is an older single-speed pump with several worn parts, a variable-speed replacement often costs less over its life once lower power use is counted. We put both numbers in front of you.
Do you work on equipment you did not install?
Yes. We repair most major pump, filter and heater brands, whoever put them in. If a part is no longer made, we tell you that up front.
Will I need to drain the pool for a repair?
Almost never for equipment work. Pad repairs are done with the system off and valves closed. If a repair truly calls for lower water, we explain why, and our Pool Drain and Refill service covers it.
How long does a typical repair take?
Many seal, o-ring and fitting repairs are finished in a single visit. Motors, heater parts and special-order items depend on availability, and we give you a realistic time once we know what is needed.
Can a repair problem be caught during weekly service?
Often, yes. On Weekly Pool Cleaning visits we watch pressure, listen to the pump and look at the pad, which helps catch a weeping seal before it becomes a failed motor.
Talk through your repair before you spend
Describe what your equipment is doing, and we will arrange a visit, find the cause and give you a clear choice between repair and replacement.